Gibson GCG91226XA Bedienungsanleitung PDF herunterladen (Seite 26)

Changing from liquid gas to natural

gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the oven functions back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts

are back into their initial

position. There is a risk of

injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions on

the minimum position.

6. Remove the knob for the oven functions

again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob for the oven functions back.

9. Set the maximum gas flow position on the

knob for the oven functions and let the

oven heat for at least 10 minutes.

10. Quickly turn the knob for the oven

functions from maximum to the minimum

gas flow position.

Control the flame. Make sure the flame does

not go out when you turn the knob to the

minimum gas flow position. There must be a

small regular flame on the oven burner crown.

If the flame goes out adjust the oven burner

again.

Gas grill injector replacement

1. Release the screws which keep the grill

burner in position A.

A

2. Release the burner injector with a 7 mm

socket spanner and replace it with a right

one.

3. Assemble the burner in a reverse

sequence. Before you fix the screw, make

sure that the burner is pushed correctly to

the back panel.

Test the grill injectors.

Levelling

CAUTION!

Remove all the accessories from

the oven.

1. Open the lid of the appliance and

disassemble the lid, the pan supports and

all the burner assemblies.

2. Put the appliance on the sidewall on a

clean and smooth surface. Place each

foot into a separate hole, in the plinth, and

rotate it counterclockwise.

26

1 2 ... 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare